SNR S2940-8G-v2, Configuration Manual

Page: 111 / 420

SNR S2940-8G-v2 Switch Configuration Guide
CFM-OAM Configuration
7. Configure RMEP
Command Explanation
MA Configuration Mode
continuity-check receive rmep
<mep-id> [active time < time >]
no
continuity-check receive
rmep <mep-id>
Open CCM message receiving function and build up rmep
in MA. If the mepid in an MA has been configured as MEP,
it cannot be configured as RMEP. No command deletes the
configured RMEP.
8. Create MIP (selectable)
Command Explanation
MD Configuration Mode; MA Configuration Mode
mip auto-create [ lower-mep-
only | none ]
no mip auto-create Configure the automatic MIP in the maintenance collection's
domain. As default, there is no rule of configuring the mid
point; and it does not carry the sender-id. No command
deletes the MIP.
Global Mode
ethernet cfm mip auto-create
level < level-id > vlan < WORD
> [lower-mep-only] [sender-id
chassis]
no mip auto-create Build up the MIP configuration on the layer that does not
relate to MA. As default, there is no rule of configuring the
mid point; and it does not carry the sender-id. No command
deletes the MIP.
9. Enable the failure confirmation function (selectable)
Command Explanation
Global mode
ethernet cfm alarm { delay <
mseconds > | notification { all
| error-xcon | mac-remote-error-
xcon | none | remote-error-xcon
| xcon } | reset < mseconds > }
no ethernet cfm alarm { delay
| notification { all | error-xcon |
mac-remote-error-xcon | none |
remote-error-xcon | xcon } | reset
} Enable the function of error alarm. No command recovers
to be default.
ethernet cfm logging
no ethernet cfm logging Open the log record function. If alarm is occur, it means that
has already recorded or inform out of order. No command
disables this function.
ethernet cfm snmp-server en-
able traps
no ethernet cfm snmp-server en-
able traps Having the snmp notification during the alarm. If the set up is
success, it will have the snmp notification during the alarm.
No command disables this function.
111