SNR S2940-8G-v2, Configuration Manual

Page: 48 / 420

SNR S2940-8G-v2 Switch Configuration Guide
Port Configuration
(l) Configure interval of port-rate-statistics
3. Virtual cable test
1. Enter the Ethernet port configuration mode
Command Explanation
Global Mode
interface ethernet <interface-
list>
Enters the network port configuration mode.
2. Configure the properties for the Ethernet ports
Command Explanation
Port Mode
media-type { copper | copper-
preferred-auto
| fiber | sfp-
preferred-auto }
Sets the combo port mode (combo ports only).
shutdown Enables/Disables specified ports.
no shutdown
description <string>
Specifies or cancels the name of specified ports.
no description
mdi { auto | across | normal }
no mdi
Sets the cable type for the specified port; this command is
not supported by combo port and fiber port of switch.
speed-duplex { auto [10 [100
[1000]] [auto | full | half |]]
| force10-half | force10-full |
force100-half | force100-full |
force100-fx [module-type { auto-
detected | no-phy-integrated |
phy-integrated }] | { { force1g-
half | force1g-full } [nonegotiate
[master | slave]] } | force10g-full
} Sets port speed and duplex mode of 100/1000Base-TX or
100Base-FX ports. The no format of this command restores
the default setting, i.e., negotiates speed and duplex mode
automatically.
no speed-duplex
negotiation { on | off }
Enables/Disables the auto-negotiation function of
1000Base-FX ports.
bandwidth control <bandwidth>
[both | receive | transmit] Sets or cancels the bandwidth used for incoming/outgoing
traffic for specified ports.
no bandwidth control
flow control
Enables/Disables traffic control function for specified ports.
no flow control
loopback
Enables/Disables loopback test function for specified ports.
no loopback
48