Snow Hawk 600HO, Set-Up, Service And Shop Manual

Page: 203 / 207

WIRE, CABLE AND HOSE ROUTING 16-11
3
Fuel hoses
Fuel pump
The fuel pump uses 3 hoses to function properly:
1. Impulse (Vacuum) Hose
Once installed onto the pump, the impulse hose follows the
MAG side chassis and is then connected to the rear of the
engine, as shown at right. Ensure that the spring clamps are
well placed.
2. Fuel Hose from Fuel Tank
The black 5/16 in. fuel line follows the MAG side chassis
towards the rear of the vehicle and is then connected via a
reducer to the 1/4 in. clear fuel line that goes into the fuel tank.
The clear line must pass between the fuel tank and the airbox.
ENSURE that the fuel line does NOT become pinched.
.
3. Fuel supply line (to carburetors)
The carburetor fuel supply line is routed form the pump,
between the engine plate and engine itself and then back up
and into the black tee connection at the base of the rack of
carburetors. Ensure that the spring clamps are well secured.
◆
WARNING
It is very im[portan that all of these hoses are installed
exactly as shown in the photos at right.
2
1
2