Snow Hawk 600HO, Set-Up, Service And Shop Manual

Page: 16 / 207

GENERAL INSTRUCTIONS 1 - 6
Drive Belt
A new drive belt must be submitted to a 5-hour break-in period.
Avoid high-speed driving and brisk accelerations during this
period.
Inspection – 10 hours
A general inspection is recommended after the first 10 hours of
use. This inspection must be carried out by an authorized
SNOW HAWK ™ dealer.
●
NOTICE:
o
Most of the wear in this vehicle occurs during the break-in
period.
o
Bolts and nuts can easily become loose in a new machine.
Make sure you check them regularly during this period.
REMOVAL OF THE BODY PANELS (HOOD, REAR
MODULE AND BELLYPAN)
In order to work on the vehicle more easily and to access the
anchor ties, we suggest that you remove the rear module from
the vehicle. To do so, you must first remove the hood. Proceed
as follows:
o
Disconnect the front headlight.
o
Unhook the 4 rubber latches (2 / side).
o
Remove the hood.
o
Remove the fuel tank cap.
o
Set the choke to the full position.
o
Unplug the tail light connector located under the light
itself, underneath the rear fender.
o Release the rear module from its four rubber latches,
slip the rewind starter handle through the space
provided and remove the rear module.