Snow Hawk 600HO, Set-Up, Service And Shop Manual

Page: 107 / 207

PRIMARY TRANSMISSION SYSTEM 8-9
Small bushing
● NOTICE:
The procedure described below can be carried out using a press
and the same tools.
o
Install the extractor in a vise.
o
Heat the part where the bushing is located. Turn the
extractor handle and the half-pulley at the same time to
take the bushing out.
IMPORTANT :
The screws and washers of the large bushing must be removed
before the small bushing is installed.
o
Coat the outside circumference of the bushing with
Loctite 609 (P/N 413703100).
o
Install the bushing as shown in the picture.
REASSEMBLING
Cam slide
o
When replacing the slider blocks, always install 3 new
slider blocks to ensure uniform pressure on the cam. To
re-assemble the parts of the secondary, carry out the
operations for disassembly in the reverse order.
Cam
o
Coat the inside of the cam with anti-seize compound.
INSTALLATION
Jackshaft and anti-seize compound
▼
CAUTION
Always apply anti-seize compound (P/N 413701000) on
the jackshaft before the final installation of the pulley.
Re-install the secondary clutch by carrying out the operations for
removing it, in reverse order
Check the axial play of the secondary clutch on the countershaft
by pushing the pulley toward the outside housing so that it
comes into contact with the inside shims (P/N 504108200).
Measure the axial play where the fixing screw is situated
between the shim(s) and the pulley. See the illustration.
TYPICAL - AS SEEN FROM ABOVE
1. Shims (P/N 504108200) (if needed)
2. Contact
A. 0 to1 mm (0 to 3/64 in)