Snow Hawk 600HO, Set-Up, Service And Shop Manual, Page: 134 / 207

FRONT FORK AND TWIN-AXIS SKI 11 – 8
Snow Hawk Special Tool
Fork top cap
Coupling nut
Swingarm bushing
(SH415) holder
FRONT FORK
Removal
o
Loosen the fork leg top cap before removing the leg
from its supports.
Disassembly
o
Clean the fork.
●
NOTICE:
The Paioli tool kit (P/N 449 450 020) is needed to perform
modifications such as seal replacements and complete fork
disassembly. For smaller operations such as fluid changes
and/or compression valving adjustments, the supplied special
tool is sufficient.
▼
CAUTION
Scratches or other damage to inner tube surfaces or
gasket edges may cause oil leaks.
Scratches and other damage must be avoided. Use a mild
detergent or an automobile cleaning product to dislodge
any dirt.
▼
CAUTION
An inadequate dismantling of the fork leg top cap may
damage the rebound adjustment needle resulting in a
malfunction of the system.
To prevent such a situation, set the rebound adjustment
to its fastest position (by turning it counterclockwise)
before taking the cap off.
Take note of the initial position of this adjustment by
counting the number of "clicks" between the initial
position and the point where a slight resistance is felt
(turning clockwise).
o
Unscrew the fork leg top cap completely while holding
the outer tube. Lower the outer tube slowly until it
comes into contact with the lower section of the inner
tube.
o
Using your hand, push the top part of the spring down to
provide enough space to insert the open end of a
spanner wrench.