Snow Hawk 600HO, Set-Up, Service And Shop Manual

Page: 179 / 207

ELECTRICAL SYSTEM 14-5
CDI SYSTEM
● NOTICE:
The following procedures can be carried out without removing the
engine from the vehicle. Only the body panels must be removed.
For more details, see
Chapter 1 – General Instructions .
CDI means Capacitor Discharge Ignition System
CLEANING
Clean all metal components in a non-ferrous metal cleaner.
▼
CAUTION
Clean stator and magneto using only a clean cloth.
DISASSEMBLY
3, Magneto Flywheel
To gain access to magneto assembly, remove the following parts:
o
All body panels
o
rewind starter
o
starting pulley no. 8.
To remove magneto flywheel retaining nut on the end of the
crankshaft (not shown in exploded view):
o
Use magneto puller ring (P/N 420 876 080). This puller
must be modified as shown at right. (cut 25mm from the
tab)
o
Install puller ring with its tab in magneto housing
opening (No 1 at right).
▼
CAUTION
Use only M8 x 30 mm screws (No. 2 at right) to bolt puller
to magneto.
o
Remove magneto flywheel nut and lockwasher using a
30 mm socket machined to 40 mm (1.580 in) outside
diameter by 16 mm (5/8 in) long.