Snow Hawk 600HO, Set-Up, Service And Shop Manual

Page: 42 / 207

FUEL SYSTEM 3 - 13
CHOKE CABLE ADJUSTMENT
Adjust choke cable as per following procedure:
Loosen choke cable housing adjusting and locking nuts.
Connect choke cable on starter lever # 57.
While choke lever is fully open, pull choke cable until starter
lever reaches the stopper. Tighten cable housing adjusting and
locking nuts in this position.
As a confirmation, the gap between the stopper and the bracket
should be within 0 and 0.5 mm (0 and 1/64 in).
A - Within 0 and 0.5 mm (0 and 1/64 in)
Idle Speed Final Adjustment
Start engine and allow it to warm then adjust idle speed to
specifications by turning idle speed screw clockwise to increase
engine speed or counterclockwise to decrease it.
Refer to Chapter 15 – Dimensions and Tolerances for the
specifications.
● NOTICE:
Do not attempt to set the idle speed by using the pilot screw.
Severe engine dam-age can occur.