SKF UFD10 Series, Assembly Instructions Manual

Page: 106 / 130

EN
8. Communication with machine control unit
- 106 -
951-170-218-EN
Version 06
Lubrication programs, Table 14, (2 of 2)
Program
No.
Output byte 1 Air volume
flow Lubricant volume
flow
1 ) [ml/h]
Cooling duct diameter
of tool [mm]
7 6 5 4 3 2 1 0 1 duct 2 ducts
26
0 0 0 1 1 0 1 0
Automatic
control
5 1x1.5 to 2 2x1.1 to 1.4
27
0 0 0 1 1 0 1 1 10
1x2 2x1.4
28 0 0 0 1 1 1 0 0 15
40
0 0 1 0 1 0 0 0 7.5-15
1x2.5 to 5 2x1.8 to 3.5
41
0 0 1 0 1 0 0 1 15-20
42
0 0 1 0 1 1 0 0 20-35
43
0 0 1 0 1 0 1 1 30-45
44
0 0 1 0 1 1 0 0 45-50
45
0 0
1
0
1 1
0
1
55-65
50 2 )
0 0 1 0 0 0 1 0 2-10 1x0.5 to 1.0 2x0.4 to 0.7
1)
The lubricant flow volumes indicated here are guiding values only. They relate to oil type “SKF LubriOil” at a primary pressure of 6 bar with a tolerance of
± 20%. The measurements were conducted according to SKF Measuring Instructions No. 245-940.00.
2) Only on MQL devices with bypass control. This program number is only to be used for deep-hole bores on tools with cooling ducts < 1 mm. If this pro-
gram number is used, a check must be performed as to whether the bypass valve actually opens and closes continuously (cycles) in the drilling process.