- 14 -
951-170-218-EN
Version 06
EN
1. Safety instructions
○
Take appropriate measures to ensure
that moving, detached parts are immo-
bilized during the work and that no limbs
can be pinched by unintended move-
ments.
○
Assemble the product only outside the
operating range of moving parts, at an
adequate distance from sources of heat
or cold. Other units of the machine, the
vehicle must not be damaged or impaired
in their function by the installation.
○
Dry any wet, slippery surfaces or cover
appropriately.
○
Cover hot or cold surfaces appropriately.
○
Work on electrical components may be
performed only by qualified electricians.
Note possible waiting times for discharge.
○
Work on electrical components may be
performed only when the components
are in a de-energized state and using
tools suitable for electrical work.
○
Establish the electrical connection only in
accordance with the valid circuit diagram
and in observance of the relevant regula-
tions and the local electrical operating
conditions.
○
Do not touch cables or electrical compo-
nents with wet or moist hands.
○
Fuses must not be bridged. Always re-
place defective fuses with fuses of the
same type.
○
Drill required holes only on non-critical,
non-load-bearing parts. Use existing
boreholes. Do not damage lines or cables
when drilling.
○
Observe any possible wearing spots. Pro-
tect components appropriately.
○
All components used must be designed
for:
- The maximum operating pressure
- The maximum/minimum ambient
temperature
○
No parts may be subjected to torsion,
shear, or bending.
○
Check parts for contamination before use
and clean if necessary.
○
Lubrication lines should be filled with lu-
bricant prior to assembly. This simplifies
subsequent venting of the system.
○
Adhere to the specified torques. Use a
calibrated torque wrench when tighten-
ing.
○
Use suitable hoisting equipment when
working with heavy parts.
