Simrad ER60, Operator'S Manual

Page: 24 / 182

Simrad ER60 Operator manual
16
850-164692 / Rev.B
Power on/off
Use the following procedures to switch the ER60 echo sounder
on and off.
Power on
It is assumed that the echo sounder’s hardware and software are
properly installed and configured.
1 Switch power on.
- The location of the power switches are individually
assigned. The computer has its own power switch. The
transceiver(s) must be connected to separate power
supplies, and should have a remote power switch.
2 Observe the hardware test messages and operating system
start-up messages.
3 Start the ER60 program.
4 If the Login dialogue box appears, enter username and
password.
5 On the Operation menu, select Normal .
6 Once the echo sounder is running, start pinging by
pressing the “arrow” (
"
) symbol on the toolbar.
Set-up
If no channels appear in the Normal Operation dialogue,
observe the following procedure:
1 Open the Transceiver Installation dialogue box from the
Install menu
2 Check that all frequency channels are properly installed.
3 Open the Normal Operation dialogue box from the
Operation menu.
4 Check the operational mode for each of the installed
channels. Adjust as required.
5 Open the Window menu, and select New channel to open
a new channel window.
Power off
To switch off the ER60 echo sounder, observe the following
procedure.
1 Select Exit on the File menu.
2 Allow the computer to close all the ER60 software
applications.
- If desired, ER60 can be restarted using the desktop
icon.