Simrad ER60 Operator manual
124
850-164692 / Rev.B
•
Entries shown in
red
are frequency channels which have
previously been installed, but are no longer available.
A frequency channel can be selected by left clicking on the
entry in the list.
Transducer
The
Transducer
box allows you to select a transducer for the
chosen frequency channel. Transducer parameters are normally
automatically updated through the calibration procedure, and do
not need to be changed manually.
You can however manually modify transducer parameters using
the
Transducer Parameters
dialogue.
Transceiver information
The dialogue displays information about the chosen transceiver.
The information includes:
•
Name
- The currently selected frequency channel
•
GPT SW Version
- The current software version in the
General Purpose Transceiver (GPT).
•
Console IP Address
- The IP address of the console running
the echo sounder software.
•
Network IP Address
- Describes which numbers must be
identical between the console IP address and the transceiver
IP address for the transceiver to be identified by the console.
Thus, the address 157.237.xxx.xxx describes that all
transceiver IP addresses must start with 157.237.
•
GPT IP Address
- Allows you to modify the IP address of
the transceiver.
Transceiver browsing
These settings allow configuration of network properties when
the system automatically searches for connected transceivers.
Local IP Address
- If the computer running the echo sounder
program contains multiple network cards the network card
which is connected to the transceivers can be selected from this
list.
Remote IP Address
- Normally the search for transceivers
should be broadcasted, and in this case the
Remote IP Address
field must be set to 255.255.255.255 and the
Communication
mode must be set to
Broadcast
. Changing the
Remote IP
Address
while selecting
Communication
mode
Point-to-Point
can be used in special network set-ups where this is required.
Summary of Contents for ER60
Page 2: ......
Page 3: ...850 164692 ER60 Scientific echo sounder Operator manual...
Page 181: ......
