Simrad ER60 Operator manual
108
850-164692 / Rev.B
Sensors
- This column is used to identify the external sensor
currently connected to the serial line.
Add
- If you have added additional serial lines to the computer
(for example by installing an extra interface circuit board), you
can press
Add
to identify the new ports. If you have previosuly
released an unused serial port, but wish to bring it back to ER60
use, you must also press
Add
to include it.
Remove
- Once the ER60 has identified and listed all the
available serial lines on the computer, these can not be used by
any other software applications on the same computer. However,
if the ER60 does not need a specific serial line, it can be
released for other use when you select it and press the
Remove
button.
Setup
- Select a serial line and press the
Setup
button to
configure the communication parameters.
LAN ports
Local IP
- This is the IP number of the network card in your
computer that you wish to use.
Local port
- This is local port you wish to use.
Remote IP
- This is the IP number of a remote computer. For
point-to-point communication, you must define this IP address.
If you wish to broadcast information, enter IP number
255.255.255.255. For inputs, you do not need to set up this
parameter.
Remote port
- Set up the remote port only if applicable for
point-to-point data export.
Protocol
- Each ethernet line can communicate with more than
one sensor simultanously provided that each sensor use the same
protocol.
Sensors
- This column is used to identify the external sensor
currently connected to the serial line.
Add
- If you wish to assign a new port to the existing network
card, or add a new network card, press
Add
to identify the new
port(s).
Remove
- Use this feature to remove ports you do not need.
Setup
- Select a LAN port and press the
Setup
button to
configure the communication parameters.
Summary of Contents for ER60
Page 2: ......
Page 3: ...850 164692 ER60 Scientific echo sounder Operator manual...
Page 181: ......
