![background image](http://html1.mh-extra.com/html/silverline/998003/998003_original-instructions-manual_1273305009.webp)
18V Combi Hammer Drill
9
silverlinetools.com
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web:
silverlinetools.com/en-GB/Support
Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
• For long-term storage, remove batteries and store separately
Disposal
Li-ion batteries should not be disposed of with household waste. If you do not know of a li-ion
battery recycling centre in your area, contact your local authority or original dealer for advice on
disposal of li-ion batteries.
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, batteries or other waste electrical and electronic equipment
(WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way to dispose of power
tools and batteries
Problem
Possible cause
Solution
Red LED (19) does not illuminate and Battery (12) not charging
Battery not fully seated
Clean Battery and Battery Charger contacts
Battery Charger (16) not powered
Recheck mains connection
Battery has low capacity
Battery not being fully charged
Charge the Battery until Red LED is extinguished
Battery has been charged over 300 times and capacity has
started to reduce
This is normal for batteries. Contact your Silverline dealer to
purchase a replacement battery
Drill cannot be switched ‘ON’ (ON/OFF Trigger Switch (15) does
not move)
The Forward/Reverse Switch (8) may be in the middle
(“locked”) position
Slide the Forward/Reverse Switch either to the left or right
Drill does not start when ON/OFF Trigger Switch is pressed
Battery completely discharged
Recharge Battery or replace with a fully charged battery
Defective Battery
Replace Battery
Drill defective
Contact your Silverline dealer or authorised service centre
Screws do not reach deep enough into the workpiece
Not enough torque; Torque Selector (3) setting too low
Choose a higher torque setting
Low battery voltage
Recharge Battery or replace with a fully charged battery
Screws are driven too deep into the workpiece surface
Too much torque; Torque Selector (3) setting too high
Choose a lower torque setting
Troubleshooting
998003_Manual.indd 9
26/03/2020 16:54
Summary of Contents for 998003
