Silca Unocode 299, Operating Manual

Page: 44 / 67

UNOCODE 299 Operating manual - English
40 Copyright Silca 2002
5.8 E
RROR MESSAGES
• The selected data card is for a different
clamp from the one installed on the machine.
Install proper clamp.
• The entered data card number is not
available in the machine’s data base.
• The entered cuts cannot be carried out (see
ch.5.2.1, page 20)
• This message appears when the cutter
must
be changed with one that is
compatible to the type of cuts required for
the entered data card number.
• This clamp is not available in the
machine’s data base.
• This cutter is not available in the machine’s
data base.
• This adapter is not available in the
machine’s data base.
• The entered data card number requires a
type of cut that is not available in the
machine’s data base.
• The minimum distance from the key stop
position overlaps the first cut on the key
(ch.5.7, page 36).
• This message appears when the cutter is
unable to identify the keys measurements
when cutting by means of electric contact.
Data card not
compatible with
clamp installed!
Non-feasible
combination!
ATTENTION !!
Install cutter:
U01
Data card
not available!
Clamp not
available!
Adaptor not
available!
Cutter not
available!
Type of cut
not available!
MIN. Parameter of
DISTANCE FROM STOP
is incompatible with
selected card!
POSITION ERROR
Key not
properly installed!