Silca Unocode 299, Operating Manual

Page: 45 / 67

Operating manual - English UNOCODE 299
Copyright Silca 2002 41
• During the cutting cycle one or more depth
exceeded the maximum limit. These depths
are automatically aligned to the maximum
permitted depth.
• The automatic setting revealed a variation
that exceeded the permitted nominal figure
setting
reference. Carefully repeat the
setting procedure.
• During the setting of the “machine’s zero
points” there is a contact failure between the
two templates (see ch.5.6.2, page 33).
• Indicates that the entered function is not yet
available.
• The electronic control board has exceeded
the maximum permitted temperature. Check
the cooling fan (ch. 7.1 "Trouble shooting",
page 43).
• Indicates that the fuse has blown due to a
short circuit in an inlet or outlet (ch. 7.1
"Trouble shooting", page 43).
• Indicates a short circuit in port P (IN/OUT)
(ch. 7.1 "Trouble shooting", page 43).
• Indicates that the fuse has probably blown
(ch. 7.1 "Trouble shooting", page 43).
• Indicates a fault on the electronic control
board.
• The Machine ID has not been set. In such
cases access cannot be gained to Protected
Systems until the Machine ID is set. Select
menu 6-12-1 and check that the Machine ID
is different from 0. To set Machine ID ask for
a Software update valid for your machine
(machine internal program version higher
than or the same as 2.0.078) and install with
the SILCA WinTransfer Program or SILCA
Code Program.
Exceeded setting
tolerance limit
See operating manual
ATTENTION
Depth limit
exceeded!
Non-feasible
function !
TEMPLATE ERROR
no contact made.
See operating manual
TEMPERATURE ALARM
Turn the machine off!
I/O POWER ALARM
Check fuse F4 !
DIGITAL OUTLET
PROTECTION ALARM
Turn the machine off !
CUTTER MOTOR
ALARM
Check fuse F1 !
CUTTER MOTOR
ALARM
Fault on motor circuit !
ERROR
Machine ID
not defined
See operating manual