Silca Unocode 299, Operating Manual

Page: 37 / 67

Operating manual - English UNOCODE 299
Copyright Silca 2002 33
5.6.2 M
ACHINE ZERO POINTS
With the use of regulating templates (Ch.1.5 "Accessories provided", page 7) the machine provides a ‘self-
setting’ procedure. These procedures must be carefully carried out following the descriptions and
illustrations indicated below.
PRELIMINARY OPERATIONS
1) turn the machine off and unplug it from its power supply cable.
2) remove the bottom panel (ch.7.9, page 50).
3) plug the machine’s power supply cable back into place.
4) turn the machine on and carry on with the procedures described on page 33.
Procedure:
1) enter the “Maintenance” #5.
2) select “Machine zero points” #2.
Operational keys:
use the keys to move the cursor to the option required
and press ENTER or directly press the numbered key corre-
sponding to the option number.
3) remove the V100 clamp from its support.
4) insert the (Z2) template, the clamp’s
bushing and secure them with the clamp’s
knob (fig. 26).
5) remove the cutter (ch.4.6, page 16) and
insert the (Z1) template into place (fig. 26).
6) manually move the X and Y axis up until
the (Z1) and (Z2) templates make contact
(see fig. 26 - top view).
7) lower the protective shield and press
START.
ATTENTION: check that both the (Z2) and (Z1) templates
make perfect contact (fig. 26). If this does
not occur the display will show an error
message
.
- the machine will take the X and Y
axes to a predefined position.
EVENT MACHINE ZEROES CALIBRATING (Ch. 5.5, page 26)
CLAMPS CUTTERS
Replacement of
the electronic board YES
(see ch.7.6, page 48)
YES
(see ch.7.6, page 48)
YES
(see ch.7.6, page 48)
Replacement of sensors YES NO NO
Replacement of the cutter shaft YES NO NO
Replacement of the ball screws YES NO NO
1 - Test
2 - Machine ‘0’ point
5 - Maintenance
6 - Options
Install Z1 & Z2
templates.
See operating manual.
Move X and Y axis
up until contact is made
See operating manual.
TEMPLATE E R R O R
No contact made.
See operating manual.
ENTER
START
ENTER