Silca Unocode 299, Operating Manual

Page: 31 / 67

Operating manual - English UNOCODE 299
Copyright Silca 2002 27
3) replace the cutter with the (Z1) template (fig.
22). To remove the cutter follow the
instructions on page 16, ch. 4.6 "Changing
the cutter".
4) insert the (Z3) template to the side of the
V100 clamp that is shown on the machine’s
display.
5) close the protective shield.
6) press START.
- this will automatically start the setting of
the V100 clamp by means of electric
contact between the two templates.
- the display shows the differences from
the theoretical values.
7) to save the data press ENTER.
ATTENTION: if the STOP key is pressed, the new settings
will be lost. If so, only the previous setting
values will remain valid.
NOTE: the settings will be accepted only if the
tolerances remain within a range
between –30/+30 hundredths of a mm.
- if the tolerances exceed the accepted
range the machine’s display will show
an error message:
- carefully follow the instructions and
repeat the procedure.
Fig. 22
V100 SIDE A
Install Z1 & Z3 temp.
See operating manual
[START]
V100 SIDE A
Detection
in progress!
V100 SIDE A
X = +002 Y = +004
Save data?
No = STOP Yes = ENTER
Exceeded setting
tolerance limit.
x = +50 y = +2
See operating manual.
ENTER
ENTER
START
Z1
Z3
Z1
Z3