Silca Unocode 299, Operating Manual

Page: 6 / 67

UNOCODE 299 Operating manual - English
2 Copyright Silca 2002
GENERAL
UNOCODE 299 has been designed in compliance to the European Community normative (CE).
From the design stage risks for the operator have been eliminated in all areas: transport, regulation, cutting
and maintenance.
Further risks have been eliminated by means of protective devices.
The materials used to manufacture this machine and all its components are not hazardous.
U
SE
UNOCODE 299 is designed for cutting keys of ferrous materials: brass, silvernickel, etc.
It must be installed and used according to the instructions indicated by the manufacturer.
If the key-cutting machine is used differently or for purposes different from those described in this manual,
the customer will forego any rights he may have over Silca S.p.A. Furthermore, unforeseen danger to the
operator or any third parties may arise from incorrect use of the machine.
I
NCORRECT USE
Operator negligence resulting in improper use of this machine or failure of the operator to observe the
instructions written in this manual. The manufacturer may decline all guarantees and responsibilities.
It is therefore essential to carefully read this operating manual.
I
MPROPER USE OF ELECTRIC CONTACT
CAUTION:
•
it is not permitted to cut ultralite anodized aluminium keys, plastic keys or any keys with materials
that do not have electrical conductivity by means of electric contact.
• cuts cannot be repeated on the same side of the key when electric contact cutting is used.
F
URTHER RISKS
No further risks will arise when properly using the UNOCODE 299.
P
ROTECTION AND SAFETY PRECAUTIONS FOR THE OPERATOR
UNOCODE 299 is entirely built in compliance to the Machine Directives. The operations for which it has
been designed are easily carried out with no risk to the operator.
The adoption of general safety precautions and observation of the instructions provided by the
manufacturer in this manual eliminate all human error, unless deliberate.
UNOCODE 299 is designed with features which make it completely safe.
• Power supply
UNOCODE 299 is supplied with electricity by means of a grounded plug and differential switch.
• Start-up
The machine is turned on by means of a master switch that is located on the Unocode’s lower left back side.
• Maintenance
The operations to regulate, service, repair and clean the machine are structured in the simplest and safest
way possible. Parts that the operator can dismount cannot be incorrectly replaced therefore avoiding any
risks.
• Machine identification
The machine is provided with an identification label which includes the machine’s serial number (fig. 2).
Fig. 2
N˚ MATRICOLA
SERIAL No.
Telefax (0438) 913800
Telex 410579 SILCA I
SILCA SpA - Via Podgora 20 (Z.I.)
31029 VITTORIO VENETO (TV) ITALY
TIPO
TYPE
VOLT
A. Hz. WATT
(0438) 9136
☎
®
CE mark
year of
manufacturer’s
address
serial No.
working
working
frequency
absorbed
current
absorbed power
type of
voltage
manufacture
machine