Silca Unocode 299, Operating Manual

Page: 41 / 67

Operating manual - English UNOCODE 299
Copyright Silca 2002 37
4 - C
ARRIAGE APPROACH SPEED
:
This is the speed at which the carriages move
towards the cutting area, before starting the
cutting cycle.
We recommend to operate the machine with the
speed that is set (4000). If required, the operator
can adjust the carriage approach speed from a
minimum of 1000 to a maximum of 5000.
5 - M
INIMUM DISTANCE
:
The number shown on the machine’s display
represents the X axis distance between the key
blank shoulder and the beginning of the first cut
(fig. 30).
This function is extremely important with keys
that require cuts on both sides as it ensures
precise positioning on the key 2nd side.
Fig. 30
The set figure is 50 hundredths of a mm, which
can be varied between min.0 - max. 99
hundredths of a mm.
ATTENTION: settings that are too high may render
precise cuts impossible, with the following
message on the display:
6 - M
ODIFY KEYS STOP
:
Normally the machine does not require key
shoulder stop adjustment.
If required, it is possible to modify the key’s
shoulder according to the modification made to
the key shoulder (fig. 31).
If the operation is confirmed (with SHIFT+
), 4
items are required:
thickness X:
measurement of the shoulder stop to be cut is
expressed in hundredths of a mm (min.0 -
max.99).
height Y:
height of the shoulder read on the key using a
calliper, expressed in hundredths of a mm. E.g.:
•
Y = 3 mm = 300 hundredths
depth H:
depth of the part to be removed, expressed in
hundredths, referred to the measurement of the
key blank.
length L:
movement of the cutter axis referred to X.
Fig. 31
Carriage approach
speed = 4000
(1000 - 5000)
Min. distance
of cut from key stop = 50
(0 - 90)
Min. Parameter of
DISTANCE FROM STOP
is incompatible with
selected card!
Modify key stop
Enabled = YES
Thickness X = 0
Height Y = 300
Depth = H = 100
Length = L = 50