Silca Unocode 299, Operating Manual

Page: 58 / 67

UNOCODE 299 Operating manual - English
54 Copyright Silca 2002
7.12 WIN-TRANSFER P
ROGRAM FOR LOADING
/
UPDATING THE INTERNAL MACHINE
PROGRAM
The machine is supplied with an internal program already loaded and tested in our workshops. The user
therefore does not need to carry out any operations.
Only in the situations described below can the WIN-TRANSFER program be used to re-start the machine.
The following is a list of situations where the use of the WIN-TRANSFER program is required.
For further details on installation and use of the program, follow the instructions given on the
instruction sheet provided with the disk or CD ROM.
• Replacement of the electronic board (see ch. 7.6, page 48) or loss of the internal
machine program.
1) replace the board with a new one, if necessary.
2) install on your personal computer the latest version received of the WinTransfer program and follow the
instructions given on the instruction sheet provided with the program.
3) read the serial number on the data plate on the back of the machine (ch.5.8, page 40) and enter on the
machine.
4) gauge the machine according to the instructions in the manual, as follows:
- gauge as explained in chapter 5.6.2 "Machine zero points" in the user’s manual.
- gauge the V100 clamp (ch. 5.5.1, page 26).
At this point the machine is set up and ready for operation.
• At this point the machine is set up and ready for operation
1) install on your personal computer the latest version received of the WinTransfer program and follow the
instructions given on the instruction sheet provided with the program.
• Loading of customized key data cards provided by SILCA on Customer’s request
1) install on your personal computer the latest version received of the WinTransfer program and follow the
instructions given on the instruction sheet provided with the program.