Silca Unocode 299, Operating Manual

Page: 14 / 67

UNOCODE 299 Operating manual - English
10 Copyright Silca 2002
3 MACHINE INSTALLATION AND PREPARATION
The key-cutting machine can be installed by the purchaser and does not require any special skills.
It is supplied ready for use and does not need any special set up. However, the operator may have to
control a few things before operating the machine.
3.1 C
HECKING FOR DAMAGE
UNOCODE 299 is solid and compact and will not normally damage if transport, unpacking and installation
have all been carried out according to the instructions in this manual. However, it is always advisable to
check that the machine has not suffered any damage.
3.2 E
NVIRONMENTAL CONDITIONS
To ensure that the best use is made of the key-cutting machine, it is important to place it in a well-aired
area which is not too damp.
The ideal conditions for the machine are:
temperature between 10˚C and 40˚C; relative humidity: approx. 60%.
3.3 P
OSITIONING AND INSTALLATION
1) Place the machine on a horizontal surface, solid enough to support the weight of 34,5 Kg.
- to work with ease, we suggest that the workbench be approximately the height of the operator’s
hip.
- it is important to leave clearance of at least 30 cm behind the machine and on each side to en-
sure proper ventilation.
2) Ensure that the machines voltage is the same as that of the mains power supply, which must be
properly earthed and provided with a differential switch.
- connect the power supply cable to the power supply socket.
Fig. 7
30 cm
30 cm
100 cm
30 cm