Siemens SIMOTICS FD 1MM1 Series, Operating And Installation Instructions

Page: 26 / 178

Certificates that can be downloaded
You can download certificates for the SIMOTICS motor series at the following link:
Certificates (
https://support.industry.siemens.com/cs/ww/en/ps/13358/cert )
The following directives are not relevant
● European EMC directive: The products are not considered as devices in the sense of the
directive.
● European Machinery Directive: However, the use of the products in a typical machine
application has been fully assessed for compliance with the main regulations in this directive
concerning health and safety.
● China Compulsory Certification (CCC): The SIMOTICS motor series does not fall under the
area of application.
Rotors
The rotor assembly is pressed onto the shaft together with the cage winding. The drive end of
the shaft usually has a cylindrical shaft end. Dependent on the design, a second shaft end may
be located at the non-drive end.
Drive
The motor speed is controlled using a converter. It has been optimized for operation with
SINAMICS low-voltage converters.
Other converters must comply with certain requirements: You can find more information in the
catalog or in the engineering documentation.
NOTICE
Destruction of the machine when operated directly from the line supply
The machine will be destroyed if it is directly connected to the line supply. Only operate the
machine using a converter.
Cooling
The cooling system is designed as a closed, internal cooling circuit. The heat lost from the
machine is dissipated to the ambient air via the machine's surface. A shaft-mounted fan moves
the cooling air in the primary circuit. Movement of the cooling air in the secondary circuit is
driven by a shaft-mounted fan.
Description
SIMOTICS FD 1MM1
26
Operating Instructions 02/2019