Alarm reset mode and stack alarm handling
85
Siemens Building Technologies
Fire Safety & Security Products
06.2008
z
Permanently enabled activation/deactivation of the alarm lines
(Set using the arrow keys. The 4-digit code must be set to ‘0000’.)
z
Access code: ‘xxxx’ for activating/deactivating the alarm lines
Programming of a 4-digit access code using the arrow keys. The code allows
activation/deactivation of the individual alarm lines (see Alarm processing
function category, section 6.4.3) and of the function described above (Entering
and changing monitor cycles)
(Set using the 4 arrow keys)
13.4 Entering the access code using the keyboard
Proceed as follows to configure the keyboard to set alarm lines to active/inactive
using an access code:
The following keys must be programmed on the keyboard:
Alarm line active
,
alarm line inactive
and the digit keys.
1.
Use the digit keys to enter the first two digits of the access code.
2.
Press the
Alarm line active
or
Alarm line inactive
key
3.
Enter the third and fourth digits of the access code
4.
Press the
Alarm line active
or
Alarm line inactive
key
5.
Now switch the alarm lines to active or inactive
6.
Enter
254
using the digit keys
7.
Press the
Alarm line active
or
Alarm line inactive
key
The last two steps reverse access authorisation, meaning that any further change
to the alarm status of the individual alarm lines will require the procedure to be
repeated.
The same procedure is used for the ‘Change image sequences’ function, the only
exception being that the relevant function is performed in step 5.
