Programming keyboards
52
Siemens Building Technologies
Fire Safety & Security Products
06.2008
z
Starting the positioning sequence
Before a sequence can be started, it must first have been set in the OSD menu
(see operating manual) of the CDC. This menu can be reached using the
INIT
(Initialisation) function key.
Relay
This function is designed to allow remote control of 3 relays (in CDCs with position
control) to control external devices.
The following functions can be programmed using the arrow keys.
z
Camera on/off
z
Relay 1 on/off
z
Relay 2 on/off
z
Relay 3 on/off
Each activation switches the condition of the 3 relays (on/off).
The two other key functions allow the camera to be switched on and off or to
stand-by.
6.4.5 Sub-station
function
category
Fig. 37
Sub-station
Sub-station
This function key switches images from a camera that is connected to a sub-
station.
When switching a camera connected to a sub-station, the number of the sub-
station must also be indicated when switching takes place.
1.
Preselect the sub-station using the digit keys and then activate the ‘Sub-
station’ function key.
(Scroll bar in its initial position)
2.
You can also permanently assign a sub-station to a key so that the sub-
station can be called up at a single key press.
(Use the scroll bar to program the sub-station number)
Typical example of programmed keys
To switch camera 5 on sub-station 7 to monitor 3:
1.
Enter 7 using the digit keys and press the
Sub-station
function key
2.
Enter 5 using the digit keys and press the
Input/preselect
function key
3.
Enter 3 using the digit keys and press the
Output
function key
The desired camera will be switched to monitor 3.
