Automatic picture cycle
64
Siemens Building Technologies
Fire Safety & Security Products
06.2008
Each preset sequence can include up to 32 cameras. The cameras are switched in
ascending position number order, from position 1 to the highest position (position
32 if the sequence is full).
1.
You can assign cameras to each position at will in order to program the
desired camera switching order.
2.
The image interval time can be entered in the
Setting video mode switching
parameters for monitor x
dialogue screen (see section 5.1.2). You can
extend the display time here by up to a factor of eight.
3.
Select the
Sub-st
field if a camera is connected to a sub-station.
Starting a preset sequence using a keyboard
Starting and stopping a monitor cycle requires the
Cycle start
,
Cycle stop
and
Input/preselect
keys on the keyboard. These keys are programmed in the
Programming keyboards
dialogue screen (see section 6.4).
To start a preset sequence:
1.
Enter the table number using the digit keys
2.
Press the
Input/preselect
key
3.
Enter the number of the monitor where you wish to display the preset
sequence
4.
Press the
Cycle start
key
To stop a preset sequence:
1.
Enter the monitor number
2.
Press the
Cycle stop
key
Higher priority image switching also stops the sequence
Alternatively, it is also possible to permanently allocate the
Cycle start
and
Cycle
stop
functions to a monitor. Entry of the monitor number is not then required.
