Siemens 7ME3510, Operating Instructions Manual, Page: 58 / 214

Connecting
5.2 Sensor Wiring
FUP1010 IP67 Portable
56
Operating Instructions, 03/2012, A5E02951522-02
Track Assembly Installation
1. Perform all required menu programming steps up until the point where you respond to the
[Install Complete?] prompt.
2. Make a note of the Number Index displayed in the [Install Sensor] menu. Check to ensure
that you have a matched set of sensors. They both should have the same S/N number
but marked with either an "A" or "B" (e.g., 100A and 100B).
Note
Some sensors require a right-angle adapter. This adapter should be installed before
placing the sensors in the tracks.
3. Prepare pipe for the track mounts by degreasing the surface, if needed, and removing
any grit, corrosion, rust, loose paint or surface irregularities with the abrasive pipe
conditioning material provided.
4. If this is a horizontal pipe, place the track rail assembly against the pipe. While holding
track, place second track on pipe directly underneath (180°) and hold together in place.
5. Wrap the chain around the pipe; first onto the centering pin on the bottom track and then
onto the hook on the top track.