COMMISSIONING
6
89
8020776/12AX / 2019-05-31|SICK
Subject to change without notice
O P E R A T I N G I N S T R U C T I O N S |Free Flow Profiler
Applying the correction
▸
Click
Yes
to apply the new position values.
The position values are automatically updated in the navigation tree.
Calibrating additional sensors
▸
Calibrate the other sensor components of the profiling system by following the
procedure described above.
NOTE
Do not move the reference object
The reference object must occupy the same position for all calibration processes.
▸
Leave the reference object exactly where it is throughout the entire calibration period.
▸
Do not move the reference object.
6.6.2.3
Defining lines for determining the position of the vehicle
You can add the configuration of lines to determine the position of the vehicle in the lane.
If a vehicle passes over this line during the measurement process, a corresponding object
location message will be sent via the TEMS Info interface.
The message contains the exact time at which the vehicle crossed over the line. This
means that third-party systems (such as license plate cameras or DSRC antennas) can
assign events from other components or select the correct image from a video stream.
This mechanism is not suited for triggering time-critical tasks!
1. Go to the system function level in the navigation tree and click the
Edit system
component trigger positions
camera icon.
The input line opens for determining the positions of trigger lines.
Using the plus icon in the
Back
and
Front
areas defined trigger lines based on the zero
point of the Z-axis.
2. Use the slide control to position the position line or enter a value manually using the
input field. The line will be displayed in the visualization.
A maximum of three trigger lines can be defined.
Note
Note
