5
ELECTRICAL INSTALLATION
58
8020776/12AX / 2019-05-31|SICK
O P E R A T I N G I N S T R U C T I O N S | Free Flow Profiler
Subject to change without notice
5.3.2
Connecting to the voltage supply
The Traffic Controller FPS should be connected to the voltage supply using the power
cable included with delivery. One end of the cable has a plug connector and the other is
open. The white and black wire must be connected to the voltage supply in the control
cabinet.
The Traffic Controller FPS and the 2D LiDAR sensors can be connected to the same
voltage supply.
▸
Plug the male connector of the power cable into the female connector on the Traffic
Controller FPS and screw the connection tight.
▸
Connect the Traffic Controller FPS to the voltage supply.
Fig. 57: Electrical installation of the Traffic Controller FPS – Connecting the voltage supply
▸
Connect the wires of the black and white cable in the control cabinet as follows:
Wire color
Voltage supply
White
12 V … 36 V DC
Black
0 V
Tab. 8: Electrical installation of the Traffic Controller FPS – Connecting the voltage supply
Note
