pg.
15
Attach the first upper table support and gussets
Attach two
5/16” hex bolts, flat washers, and T-
nuts
to each side of one of the upper supports.
Slide the T-nuts into the bottom channel of the
far end of the table side (where you have
temporarily mounted the legs on the outside of
the rails). Then slide this support all the way
down to the other pair of table legs, leaving
approximately 3/16” between the leg and the
upper cross support for the gussets.
Insert a gusset between each table leg and upper
support.
Attach this to the leg using
1/2” hardware (hex
bolt with a flat washer on one side and then a
flat washer, lock washer, and hex nut on other
side).
DO NOT fully tighten the bolts on the
upper support. You will need some
room for adjustment when you
square and level the table after
assembly.
Assemble Your Shopbot PRS Gantry Tool 2015 02 27.Docx
© 2015 ShopBot Tools, Inc.
