pg.
13
Attach the legs to the table sides
Attach the first leg by sliding the T-nuts into
the T-slots on the table side. Place the leg
according to the table drawing in the back of
this guide and ensure T-nuts are lined up
with the holes. Place
5/16” hex bolts, lock
washers, flat washers and T-nuts
into the
eight holes on each of the table legs, as
shown here.
Hold a framing square against the leg and
the extrusion while you tighten the bolts.
Repeat this process with the other table
side. You should have one leg on each table
side at this point. Next, temporarily attach a
second table leg to the
outside
of each table
side (this will allow you to slide the rest of
the components down the table sides
without the legs getting in the way). It
should look like the picture to the left.
Assemble Your Shopbot PRS Gantry Tool 2015 02 27.Docx
© 2015 ShopBot Tools, Inc.
