Shimadzu 503-61000-01, Installation Manual, Page: 92 / 208

Chapter 5 Installing the Options
Mobile DaRt Installation Manual 5-4
Mounting the Photo-Receptor
Procedures for mounting the photo-receptor:
1.
Remove the side covers, the top cover and the cover of the arm joint
section. (Refer to Chapter 3.)
2.
Connect the attached cable to the photo-receptor for the remote controller
(Fig. 5-3).
3.
Mount the photo-receptor for the remote controller in place of the removed
cover of the arm joint section. Use the resin top cover and socket head bolt
that have been attached as they are.
4.
Connect and layout the cable extending from the photo-receptor for the
remote controller to JREM of XCONT-2002 board as shown in Fig. 5-4
5.
Attach the removed covers again.
Fig. 5-3 Wiring to the photo-receptor for the remote controller option
Fig. 5-4 Wiring to the XCONT-2000 board for the remote controller option
Connector on
the board
Connector
of the cable
XCONT-2002 board
NEXSC
board
JREM
JREM