Shimadzu 503-61000-01, Installation Manual, Page: 158 / 208

Appendix E Maintenance and Inspection
Mobile DaRt Installation Manual
E-iv
Procedure of the battery exchange
1.
Turn ON the key switch, and lift the arm up to the position shown in
Fig. 1.
Fig. 1 Arm position to replace the battery
Be sure to start replacing the battery after moving the arm up to the
position shown in Fig. 1. Otherwise the unit may
topple over when battery is replaced.
2.
Turn OFF the key switch and OFF the main breaker as well.
3.
Unscrew the hexagon socket head cap screws on both side (Fig. 2 (a)),
and remove the FPD box.
4.
Remove both of the side covers and the upper cover.
5.
Remove the Fix plates which are fixing the main frame and DR assy.
6.
Disconnect the cable on DR assy. However, the cable between FPD and
POWER BOX is not disconnected.
7.
Detach the PC holder and remove the PC. Remove the LAN adapter that
connects the PC and cable reel at the same time. Fig. 2 (c)
8.
Remove the six screws as shown in Fig. 2 (c), pull out the DR assy.
9.
Referring to Fig. 2 (d), remove the two screws shown with white arrow (
α
),
loosen the two screws shown with white arrow (ß), and detach the
connector shown with the black arrow. Then, lift the Link ASSY to remove.
WARNING