SEW MOVIFIT SC series, Operating Instructions Manual

Page: 107 / 148

8
Operation
MOVIFIT® SC operating displays
Operating Instructions – MOVIFIT
®
SC
107
8.1.3 Bus-specific LEDs for PROFINET
This section describes the bus-specific LEDs for PROFINET. In the following figure, the
LEDs are shown as dark:
States of the
"RUN" LED
61122AXX
RUN PS
MOVIFIT
®
SF BF 24V
-C
24V
-S
RUN link/act 1 link/act 2 DI03 DI01DI02 DI00 DI04DI05DI06DI07 DI08DI09DI10DI1
1
DI12/DO00 DI13/DO01 DI14/DO02 DI15/Do03
RUN BF SF Function
level
Meaning Troubleshooting
C T S
Green x x
• •
MOVIFIT
®
components
hardware OK
–
Green Off Off
• •
• Correct MOVIFIT
®
operation
• MOVIFIT
®
is currently
exchanging data with
the PROFINET master
(data exchange) and all
subordinate drive systems.
–
Off x x
• •
• MOVIFIT
®
not ready for
operation
• DC 24 V power supply is
not present.
• Check DC 24 V voltage
supply
• Switch MOVIFIT
®
on
again. Exchange EBOX
if problem occurs
repeatedly.
Red x x
• •
Fault in MOVIFIT
®
components
hardware.
Switch MOVIFIT
®
on again.
Exchange EBOX if problem
occurs repeatedly.
Flashing
green x x
• •
MOVIFIT
®
components
hardware cannot start.
Switch MOVIFIT
®
on again.
Exchange EBOX if problem
occurs repeatedly.
Flashing
yellow x x
• •
MOVIFIT
®
components
hardware cannot start.
Switch MOVIFIT
®
on again.
Exchange EBOX if problem
occurs repeatedly.
Yellow x x
• •
MOVIFIT
®
components
hardware cannot start.
Switch MOVIFIT
®
on again.
Exchange EBOX if problem
occurs repeatedly.
X
• Any state
Valid for selected function level:
C = Function level "Classic"
T = Function level "Technology"
S = Function level "System"
0 0
I