4
Mechanical installation
General information
Compact Operating Instructions – MOVIMOT
®
MM..D with AS-Interface
15
4
Mechanical installation
4.1
General information
• Observe the general safety notes.
• Comply with all instructions referring to the technical data and the permissible con-
ditions where the unit is operated.
• Only use the provided attachment options when mounting the MOVIMOT
®
drive.
• Use only mounting and safety elements that fit into the bores, threads and counter-
sinks provided.
4.2
Tools required
• Set of wrenches
• Socket wrench, SW8 mm
• Torque wrench
• Screwdriver set
• Compensation elements (washers and spacing rings), if necessary
4.3
Installation requirements
Check that the following requirements are met before you start installing the unit:
• The data on the nameplate of the drive matches the voltage supply system.
• The drive is undamaged (no damage caused by transportation or storage)
• The ambient temperature corresponds to the specifications in chapter "Technical
data" of the operating instructions. Note that the temperature range of the gear unit
may also be restricted, see gear unit operating instructions.
• The MOVIMOT
®
drive must
not
be installed under the following harmful ambient
conditions:
– In potentially explosive atmospheres
– Oils
– Acids
– Gases
– Vapors
– Radiation
– etc.
• When the drive is installed in abrasive ambient conditions, protect the output end
oil seals against wear.
21328994/EN – 11/2014
