SEW-Eurodrive MOVIMOT MMxD Series, Compact Operating Instructions

Page: 50 / 68

6
Startup of MOVIMOT ® with MLK30A in Easy mode
Startup procedure
Compact Operating Instructions – MOVIMOT
®
MM..D with AS-Interface
50
6.5.3 Data AS-Interface master → MOVIMOT ®
The following table shows the 4 data bits that the AS-Interface master sends to the
MOVIMOT
® inverter via the AS-Interface:
AS-Interface
bit
Function (
→
2 52)
DO0 CW operation/stop
DO1 CCW operation/stop
DO2 Speed f2/speed f1
DO3 Reset
1)
/controller enable
1) In the event of an edge change from "0" → "1" (only effective in case of an error)
INFORMATION
To enable the drive, AS-Interface bit DO3 "reset/controller enable" must be set.
6.5.4 MOVIMOT ® data → AS-Interface master
The following table shows the 4 data bits that the MOVIMOT ® inverter sends to the
AS-Interface master via the AS-Interface:
AS-Interface
bit Function
DI0 Ready signal
0: The MOVIMOT ® drive is not ready for operation.
1: The MOVIMOT
®
drive is ready for operation.
DI1 Manual mode
0: MOVIMOT
®
control via AS-Interface
1: MOVIMOT ® control via manual operation
DI2 Sensor input 1
0: Signal of sensor 1 = "0"
1: Signal of sensor 1 = "1"
DI3 Sensor input 2
0: Signal of sensor 2 = "0"
1: Signal of sensor 2 = "1"
21328994/EN – 11/2014