Sequoia Aircraft Corporation F.8L Falco, Construction Manual

Page: 250 / 423

l
F.8L Falco Construction Manual 24–21 Revision 4, March 1, 2002
Figure 29
❏
Install the seven wing walk supports between Sta. 1 and 2 as shown in Figure 29. See
Drawing No. 201, Sheet 1. Note carefully that one of these pieces forms the aft upper end
of the opening for the landing gear—install this with a partial saddle gusset, with support
on the bottom and aft face only.
Figure 30
❏
On the bottom of the wing, install the 20x20 spruce strip between Sta. 1 and 2 which
forms the aft lower end of the opening for the landing gear. See Figure 30—for clarity all
framing on the upper side of the wing has been eliminated from this illustration.
❏
On the bottom of the wing, install the framing for the access panel between Sta. 2 and 2-
1/2. See Figure 30. The piece at the aft end of the bay is 10x20 spruce and its forward face
should be located 80mm forward of the aft face of the aft wing spar. This will make things
work out right for the flap hinge fairing—see Drawing No. 814. The other framing for the
access panel are 10x10 spruce strips which follow the lower wing contour and then up on
the inboard face of the Sta. 2-1/2 rib and the outboard face of the Sta. 2 rib to the 10x40