SEF 551.10, Operating Manual

Page: 143 / 238

Page 8.11
8.0 System settings
System_settings 551.19 \ 12.2015 \
Standby parameters
Soldering systems with activated function "Power Save Package"
change after a defined time in no-load operation into standby mode.
As no-load time a time is defined in which the PCB sensor recognises
no PCB at the inlet. In standby mode the system cools down to the de-
fined standby temperature.
As soon as the sensor recognises a new PCB the conveyor stops until
the system has heated up again to the set temperatures defined in
the soldering profile. After the system has reached the "Ready" status
again the production goes on automatically.
y
Tip on the function key <Set up> in the system screen.
y
Under <Standby time> enter the maximum requested no-
load time in seconds.
[1 hour = 3600 s].
y
Under <Standby temperature> enter the requested re-
duced temperature.
y
With <Back> you can change back to the system screen.
From now on the standby mode will be activated if no PCB is recog-
nised by the PCB sensor within the set standby time.
As a first step the system will change to mode "cooling" until the tem
-
perature is reached which is set as standby temperature in all heating
zones. Now the mode "Standby" will be shown.
y
By placing a PCB on the sensor or by pressing <System
stop> and immediately pressing <System start> you can
change to heating operation and make the system "ready".
Set standby time
Set standby tem-
perature
"Power Save
Package"