Seat Tarraco 2020, Owner'S Manual

Page: 333 / 424

Help with parking and manoeuvring
Parking
●
If necessary, press the

button before
passing in front of the selected parking
space.
● With reverse assist connected and in work-
ing order, press the function button

.
●
Turn on the corresponding turn signal on
the side of the road where you want to park.
●
Place the vehicle parallel to the parking
space, approx. 1 meter away.
●
If obstacles protrude from the auxiliary box-
es, find another parking space or realign the
vehicle.
●
Select reverse gear. A red frame represents
the target position of your vehicle.
●
Turn the steering wheel until the red frame
is between the auxiliary boxes and has
changed to green. Keep the steering wheel in
this position and start driving slowly.
●
When an arrow appears, reverse. A yellow
line and a green line appear. The arrow indi-
cates the distance that still has to be cov-
ered.
●
While reversing, keep the steering wheel in
the adjusted position. Adjust the steering
wheel rotation correctly when an indication
appears on the steering wheel symbol

.
●
Reverse until the STOP signal is shown or
until the green line matches up with the later-
al boundary of the parking space.
● Stop the vehicle. Turn the steering wheel as
far as it’ll go in the opposite direction.
●
Reverse until the STOP signal is shown or
until the red line reaches the rear boundary.
Problems and solutions
The system behaves differently than ex-
pected
There can be several causes:
●
The camera is dirty
›››
page 378 . In addition
to dirt and snow, camera visibility can be re-
duced by detergent residue or any type of
coating.
●
The system requirements must be met
›››
page 329 .
●
The camera is covered with water.
●
The factory-fitted towing bracket must not
be electrically connected to a trailer
›››
page 339 .
●
The vehicle has some type of damage in
the camera area, e.g. due to a parking im-
pact.
●
The field of view of the camera is blocked
by an accessory, e.g. a bicycle carrier sys-
tem.
● Changes have been made to the paint in
the camera area, or structural modifications
have been made to a component such as the
running gear.
Camera with no visibility, fault message,
the system disconnects
●
Clean the camera or remove possible ad-
hesives or accessories from it
›››
page 378 .
● Check for visible damage.
Possible solution
●
Temporarily disconnect the system.
●
Check if one of the causes indicated above
has occurred.
●
Once the source of the problem has been
eliminated, the system may be reconnected.
●
If the system still behaves unpredictably,
have it checked by a specialised workshop.
331