Seat Tarraco 2020, Owner'S Manual

Page: 173 / 424

Introduction
The unit will switch off automatically when
the key is removed from the ignition or when
the on/off button is pressed (depending on
the equipment fitted or the vehicle). If the In-
fotainment system is switched on again, it will
switch off automatically after approximately
30 minutes (switch-off delay).
Note
●
The Infotainment system is a part of the
vehicle. It cannot be used in any other vehi-
cle.
●
If the battery has been disconnected, the
ignition must be activated before switching
on the Infotainment system.
Changing the basic volume
Increasing or decreasing the volume or
muting the sound
Raise the volume
: turn the volume control

clockwise or move the left thumbwheel on
the multifunction steering wheel upward

.
Lower the volume : turn the volume control

clockwise or move the left thumbwheel on
the multifunction steering wheel downward

.
Changes in volume are indicated by a vol-
ume bar on the screen. The volume can be
controlled using the steering wheel controls.
In this case, the changes in volume are dis-
played on the instrument panel by a volume
bar.
It is possible to preset certain volume settings
and adjustments. Select
 > Sound > Vol-
ume
.
Muting the Infotainment system sound
●
Turn the volume control

anti-clockwise
until it displays

.
●
OR: press the left wheel of the multifunction
steering wheel.
Playback is paused while in Media mode (ex-
cept AUX). The screen displays

.
Operation of the function buttons
and the instructions on the screen
Fig. 164
View of some of the function buttons
on the screen.
Fig. 165 Sound setup menu
Active areas of the touchscreen that call up a
certain function are called “function buttons”.
These buttons are operated by
pressing them
on the screen or holding them down .
The function buttons appear in this manual as
a “function button” and a button symbol
inside a rectangle
.
These activate functions or open submenus.
The currently selected menu is displayed in
the title bar
›››
Fig. 164
A
of the submenus.
Inactive (grey) function buttons cannot be se-
lected.
Increase or decrease the size of the im-
ages displayed on the screen
The size of the navigation map image and im-
age views can be enlarged or reduced. To do
this, slide 2 fingers across the screen to sepa-
rate them or bring them together.
»
171