Seat Tarraco 2020, Owner'S Manual

Page: 96 / 424

Operation
● Touch ( once ) the sensor surface
›››
Fig. 79
B
(arrow) on one of the front door handles.
The vehicle locks with the “Safe” security sys-
tem
›››
page 95 . The door that is used must
be closed.
●
Touch ( twice ) the sensor surface
›››
Fig. 79
B
(arrow) of one of the front door handles to
lock the vehicle without activating the
“Safelock” security system
›››
page 95 .
Unlocking and locking the boot hatch
When the vehicle is locked, the rear lid auto-
matically unlocks on opening if there is a val-
id vehicle key in the proximity
›››
Fig. 78 .
Open or close the rear lid normally .
After closing, the hatch locks automatically. If
the complete vehicle is unlocked, the rear lid
will
not lock automatically after closing it.
What happens when locking the vehicle
with a second key
If there is a vehicle key inside the vehicle and
it is locked from the outside with a second ve-
hicle key, the key inside the vehicle is blocked
for engine ignition
›››
page 246 . In order to
enable engine ignition, press the

button on
the key inside the vehicle.
Automatically disabling sensors
If the vehicle is not locked or unlocked for a
long period of time, the proximity sensors on
the passenger doors are automatically disa-
bled.
If one of the sensor surfaces on the door han-
dles is often activated in an unusual manner
with the vehicle locked (e.g. by the branches
of a bush rubbing against it), all proximity
sensors are disabled for a certain period of
time.
Sensors will again be enabled:
●
After a time.
●
OR: if the vehicle is unlocked with the but-
ton

on the key.
●
OR: if the boot is opened.
●
OR: if the vehicle is unlocked manually with
the key.
Keyless Access temporary disconnection
function*
You can deactivate the vehicle's Keyless
Access unlocking for one locking and unlock-
ing cycle.
●
Move the gear lever to position P (if the ve-
hicle has automatic gearbox), since other-
wise the vehicle cannot be locked.
●
Close the door.
● Push the central locking button

on the re-
mote control and touch the locking sensor
surface of the driver door handle
›››
Fig. 79
B
within the following 5 seconds.
Do not grasp the door handle; otherwise the
vehicle will not unlock. Deactivation is also
possible if the vehicle is locked through the
driver’s door lock.
●
To check that the function has been deacti-
vated, wait at least 10 seconds, grip and pull
on the door handle. The door should not
open.
The next time the door can only be unlocked
via the remote control or the lock cylinder.
The next time the door is locked/unlocked,
Keyless Access will be active again.
Convenience functions
To close all the electric windows and the sun-
roof using the
comfort function , keep a fin-
ger for a few seconds on the locking sensor
surface
›››
Fig. 79
B
(arrow) of the door han-
dle until the windows and roof have closed.
How the doors open when touching the sen-
sor surface on the door handle will depend
on the settings that have been activated in
the infotainment system, using the button

> SETTINGS > Opening and closing
.
CAUTION
The sensor surfaces on the door handles
could engage if hit with a water jet or high
pressure steam if there is a valid vehicle
key in the proximity. If at least one of the
electric windows is open and the sensor
surface
›››
Fig. 79
B
(arrow) on one of the
94