Section 14
HULL/BODY
Subsection 02
(ADJUSTMENT AND REPAIR)
14-02-6
SMR2002-092_14_02A.FM
– Remove one long retaining screw (front).
– Remove two short retaining screws locate in
the back lower side and hold cover firmly.
1. One long retaining screw (front)
2. Short retaining screw (one on each side in the back)
– Remove storage cover.
– Remove seven inner skin short screws (flanged
screws).
– Remove two long inner skin screws (hex screws).
1. Storage cover
2. Inner skin
3. Inner skin short screws (x7)
4. Inner skin long screws (x2)
– Use a rubber hammer to remove the inner skin
from the cover. If the inner skin is too stiff, install
a piece of 2x4 against the inner skin and hit it with
the rubber hammer.
1. Storage cover
2. Inner skin
3. Rubber hammer
– Remove connector harness from the inner skin
by cutting tie-raps.
1. Inner skin
2. Storage cover
3. Connector harness
2
F18L1OA
1
1
F18L1PA
2
3
3
4
3
3
1
F18L1QA
2
3
2
1
F18L1RA
3
3
www.SeaDooManuals.net
Summary of Contents for GTX 4-TEC 5573 2002
