Section 05
ENGINE (4-TEC)
Subsection 06
(PTO HOUSING/MAGNETO)
SMR2002_070_05-06A.FM
05-06-5
PTO SEAL
Inspection
Check the PTO seal
no. 10
on the PTO housing. If
brittle, hard or damaged, or if you see a sign of oil
leakage, replace it.
Removal
NOTE:
When drive shaft will be removed, some
oil will flow out. To prevent it, start engine, run at
4000 RPM for 10 seconds and stop engine at this
RPM. This will move oil out of PTO housing into
oil tank.
CAUTION:
Never run engine without supplying
water to the exhaust cooling system when wa-
tercraft is out of water.
Place rags under PTO housing to prevent spillage.
If spillage occurs, clean immediately with the Pul-
ley flange cleaner (P/N 413 711 809) to prevent oil
stains.
Remove:
– Oetiker clamp
no. 11
located close to the PTO
housing
– jet pump (refer to JET PUMP in PROPULSION
SYSTEM)
– drive shaft (refer to DRIVE SYSTEM in PRO-
PULSION SYSTEM)
– PTO seal
no. 22
.
1. Oetiker clamps
2. PTO seal
Installation
Reinstall removed parts in the reverse order.
COUPLING
Removal
Lock crankshaft with locking tool (P/N 529 035 821).
Refer to CRANKSHAFT LOCKING in ENGINE BLOCK
subsection.
Remove:
– jet pump
– drive shaft
– PTO seal as described above
– coupling
no. 12
using impeller remover/installer
(P/N 529 035 820).
CAUTION:
Apply some oil on the tool to protect
the seal located in the PTO coupling.
Inspection
Check if seal
no. 13
is brittle, cracked or hard.
Check coupling for worn splines.
If damaged, replace faulty part.
1
R1503motr47A
2
R1503motr48A
R1503motr49A
www.SeaDooManuals.net
Summary of Contents for GTX 4-TEC 5573 2002
