Section 07
ENGINE MANAGEMENT (4-TEC)
Subsection 03
(COMPONENT INSPECTION AND ADJUSTMENT)
SMR2002-078 _07_03A.FM
07-03-15
Removal
Remove fuel rail cover.
Disconnect the wiring harness from all sensors/
actuators.
Disconnect the EMS ECU connector from the EMS
ECU.
Cut all tie raps which are holding the wiring harness
in position.
1. Wiring harness
Remove complete wiring harness.
Installation
First connect the EMS ECU connector A to the
EMS ECU and fix the harness on the wiring sup-
port with a locking tie.
1. Locking tie
Lead the cable bundle with the injector and igni-
tion coil connectors to the fuel rail and fix it also by
using 4 locking ties.
1. Locking ties
Connect the fuel injectors, ignition coils, CAPS, CTS
and EGT to the wiring harness.
Install the engine connector on the appropriate
bracket on the wiring support.
Then fix the other bundle on the appropriate sup-
ports on the wiring support and the EMS ECU brack-
et with locking ties.
1. Locking ties
1
R1503motr200A
1
R1503motr201A
WARNING
Pay attention not to mix injectors or ignition
coils wires between cylinders. The location of
the splice connectors indicate which cylinder
wires belong to.
1
R1503motr202A
1
1
R1503motr203A
www.SeaDooManuals.net
Summary of Contents for GTX 4-TEC 5573 2002
