Section 12
PROPULSION SYSTEM
Subsection 02
(JET PUMP)
12-02-12
SMR2002-088_12_02A.FM
Wear Ring
This model is equipped with large pump. It is im-
portant that the screws retaining wear ring to hous-
ing are installed on this model.
To install ring in housing, use a square steel plate of
approximately 180 x 180 mm x 6 mm thick (7 x 7 in
x 1/4 in) and a press.
Manually engage ring in housing making sure it is
equally inserted all around. Press ring until it seats
into bottom of housing.
1. Seal lip
2. Press wear ring
If a press is not readily available, a piece of wood
such as a 2 x 4 in x 12 in long, can be used.
Manually engage ring in housing making sure it is
equally inserted all around. Place wood piece over
ring. Using a hammer, strike on wood to push ring.
Strike one side then rotate wood piece about 90°
and strike again. Frequently rotate wood piece so
that ring slides in evenly until it seats into bottom
of housing.
1. Piece of wood
2. Seal lip facing upward
3. Wear ring
Install retaining screws.
F08J06A
F08J07A
F01J5DA
1
2
F01J5EA
1
3
2
www.SeaDooManuals.net
Summary of Contents for GTX 4-TEC 5573 2002
