Section 14
HULL/BODY
Subsection 02
(ADJUSTMENT AND REPAIR)
SMR2002-092_14_02A.FM
14-02-13
– Disconnect water supply hose, water return
hose and bailer hoses.
– Remove nuts, lock washers and flat washers
retaining jet pump support.
TYPICAL
1. Remove nuts
– Using a heat gun, heat jet pump support until it
is possible to pull it.
NOTE:
Shims may have been installed between
support and body. Do not remove these shims,
otherwise jet pump alignment will be altered.
Installation
Apply Loctite RTV silicone sealant (P/N 293 800 066)
as indicated by the shaded areas in the next
illustrations. Follow also the torquing sequence as
shown in the same illustrations.
GTX DI AND GTX 4-TEC MODELS
DRAIN PLUG INSTALLATION
Refer to the following illustration to install drain plug
no. 15
.
1. Drain plug
2. Silicone sealant (P/N 293 800 086) around the middle hole and in
the screw holes
3. Torque screws to 2.2 N•m (19 lbf•
in
)
SEAT COVER REPLACEMENT
Install staples with an electric tacker such as Arrow
tacker no. ETN-50 or with a manual tacker such as
Arrow tacker no. T-50.
NOTE:
For an easier installation, it’s highly recom-
mended to use an electric tacker.
Ensure that the seat rest firmly against a hard sur-
face such as a piece of wood. This is done to get
the staples completely pushed in place.
TYPICAL
1. Piece of wood
2. ETN-50 (electric) or T-50 (manual)
F07L0AA
1
F18L28A
4
3
1
2
2
F00L2RA
3
3
1
F01L3YA
2
1
www.SeaDooManuals.net
Summary of Contents for GTX 4-TEC 5573 2002
