Section 04
ENGINE (DI)
Subsection 03
(REMOVAL AND INSTALLATION)
04-03-2
SMR2002-060_04_03A.FM
Tuned Pipe
To remove tuned pipe, refer to EXHAUST SYSTEM.
Air Intake Silencer
To remove air intake silencer, refer to AIR INTAKE.
Throttle Body
Remove air/fuel rail. Refer to ENGINE MANAGE-
MENT.
Engine Support
NOTE:
Be careful when removing engine sup-
port(s) or rubber mount adapters, shims could
have been installed underneath. Shims control
engine/jet pump alignment. Always note position
of shims for reinstallation, to avoid altering engine
alignment.
Remove engine support mount screws.
FRONT SUPPORT
1. Remove screw
REAR SUPPORT
1. Remove screws
Lifting Engine
947 DI Engine
Engine can be easily lifted using the following sug-
gested tools:
– Cut porcelain from two old spark plugs.
– Weld a lock washer approximately 20 mm (3/4 in)
diameter on each spark plug as shown.
1. Weld a lock washer
2. Old spark plug
Remove spark plugs and replace by special tools.
Hook a sling into holes of special tools.
Using a chain block, a hoist or other suitable equip-
ment, slightly lift engine to ease the remaining
component removal.
CAUTION:
Take care not to damage cable or oil
injection hoses.
Remove rear engine support.
TYPICAL
1. Rear support
F06D35A
1
1
F07F12C
F01D0AA
1
2
1
F07F12A
www.SeaDooManuals.net
Summary of Contents for GTX 4-TEC 5573 2002
