Section 05
ENGINE (4-TEC)
Subsection 05
(REMOVAL AND INSTALLATION)
05-05-4
SMR2002-069_05_05A.FM
– Install adaptor (P/N 529 035 719) on drive shaft.
1. Engine alignment adaptor
– Carefully slide shaft through support.
– Insert shaft end into engine alignment adaptor.
NOTE:
Ensure the protective hose and carbon
ring (or seal carrier) is removed to check engine
alignment.
If the alignment is correct, the shaft will
slide easily without any deflection in engine align-
ment adaptor.
TYPICAL
1. Engine alignment adapter
2. Alignment shaft
If the alignment is incorrect loosen engine support
screws to enable to align engine alignment adap-
tor with shaft end.
NOTE:
Use shim(s) (P/N 270 000 024 or P/N 270
000 025) as necessary between engine supports
and rubber mounts to correct alignment.
TYPICAL
1. Shim
CAUTION:
Whenever shims are used to correct
alignment, never install more than 5 mm
(0.196 in) shim thickness.
Engine Support Screws
Apply Loctite 243 (blue) (P/N 293 800 060) on
screw threads.
Torque engine support screws to 25 N•m (18 lbf•ft)
when procedure is completed.
1. Torque to 25 N•m (18 lbf•ft)
1
F18D18A
1
F18D17A
2
1
F18D15A
1
1
1
Loctite 243
Loctite
243
Loctite 243
F18D10A
www.SeaDooManuals.net
Summary of Contents for GTX 4-TEC 5573 2002
