Section 05
ENGINE (4-TEC)
Subsection 04
(EXHAUST SYSTEM)
05-04-8
SMR2002-068_05_04A.FM
From outside of hull, unscrew nut
no. 13
with the
exhaust outlet tool (P/N 295 000 132).
TYPICAL
1. Exhaust outlet nut
2. Tool
From inside the bilge, pull out the exhaust hose
no. 7
and the adapter
no. 14
together.
Detach the adapter
no. 14
from the exhaust hose
no. 7
.
Inspection
Inspect parts condition paying attention for cracks or
other damage. Check hose. Replace any defective
part.
Installation
Installation is essentially the reverse of the removal
procedures. However, pay particular attention to the
following:
Apply Loctite silicone sealant (P/N 293 800 086)
on the adapter flange to seal the bilge.
Test the bilge for water leaks.
F01B2AA
1
F18D0PA
2
www.SeaDooManuals.net
Summary of Contents for GTX 4-TEC 5573 2002
