Section 16
WIRING DIAGRAMS
Subsection 01
(WIRING DIAGRAMS)
16-01-8
SMR2002-094_16_01A.FM
IDENTIFICATION OF
CONNECTOR PINS
AMP Connectors of MPEM
AMP Connectors of Wiring Harness
MAIN FUSE HOLDER JOINT
CONNECTOR
DI Models
The fuse holder is located in the rear electrical box.
1. Main fuse holder joint connector
NOTE:
In the following illustrations, the joint insu-
lator has been removed for clarity purpose only. It
is not necessary to remove it to separate the joint.
The same procedure is to be used each side of the
joint.
Insert the Deutsch j
oint connector too
l (no. 114010)
on the wire and push tool toward the joint to re-
lease it. While holding the joint insulator, push the
tool until it bottoms. It is now unlocked. Maintain-
ing the pressure with the tool, pull the wire out.
1. Deutsch joint connector tool (no. 114010)
1. Hold the insulator
2. Push the tool until it bottoms
26
25
24
23
15
8
16
9
1
F04H6RA
F04H6GA
9
1
F12H0ZA
F12H10A
1
F12H11A
2
www.SeaDooManuals.net
Summary of Contents for GTX 4-TEC 5573 2002
